Course Title: 3.07 Flying Training To CPL

Part A: Course Overview

Program: C6010 Diploma of Air Transport (Airline Pilot)

Course Title: 3.07 Flying Training To CPL

Portfolio: SEH Portfolio Office

Nominal Hours: 150

Regardless of the mode of delivery, represent a guide to the relative teaching time and student effort required to successfully achieve a particular competency/module. This may include not only scheduled classes or workplace visits but also the amount of effort required to undertake, evaluate and complete all assessment requirements, including any non-classroom activities.

Course Code




Learning Mode

Teaching Period(s)

Course Contact: Raymond Meyer

Course Contact Phone: +61 3 9394 9903

Course Contact Email:

Course Description

To acquire the skills necessary to fly an aeroplane to Commercial standard.

Pre-requisite Courses and Assumed Knowledge and Capabilities

Completion of all modules 1.05 to 3.05

National Competency Codes and Titles

National Element Code & Title:

VBF932 3.07 Flying Training To Cpl


1. Define common selected aviation terminology and airmanship points applicable to briefings in air and on ground.

10. Perform level gentle, medium and steep turns, climbing & descending turns, steep descending turns, and compass turns.

11. Perform a stall and recovery, incipent spin and recovery, and spinning (if aircraft suitable)

12. Perform take-off, circuit, landing and go-round

13. Perform emergency and abnormal procedures for complete or partial engine failure, fires, smoke or fumes, system malfunctions, imminent collision, uncertain position, and poor visibility.

14. On completion of this unit the learner will be able to fly straight and level, climb and descend, turn and recover from unusual attitudes on full instrument panel and limited panel.

15. Navigate visually below 10,000 feet anywhere within Australia

16. State the dangers and methods of avoidance and of dealing with turbulence.

17. State the use and requirements for the carriage of survival equipment.

18. State the procedures for ditching.

2. List, describe and complete pre-flight information and requirements contained in pilot reference documents.

3. State and demonstrate the purpose and methods of daily and pre-flight inspections.

4. Demonstrate the use of the VHF radio, HF radio and the transponder.

5. Perform the procedures for pre-start, after-start, and shutdown.

6. Perform the procedures and checks for taxiing.

7. Operate the controls in a light General Aviation piston engine aircraft.

8. Fly straight and level flight in various configurations.

9. Perform various climbs and descents (including sideslipping if aircraft suitable).

Learning Outcomes


Overview of Assessment

Assessment may incorporate a variety of methods including written/oral activities and demonstration of practical skills to the relevant industry standards. Participants are advised that they are likely to be asked to personally demonstrate their assessment activities to their teacher/assessor. Feedback will be provided throughout the course.