Course Title: Fabricate and install steel pressure piping

Part A: Course Overview

Program: C3171 Certificate III in Plumbing

Course Title: Fabricate and install steel pressure piping

Portfolio: SEH Portfolio Office

Nominal Hours: 16

Regardless of the mode of delivery, represent a guide to the relative teaching time and student effort required to successfully achieve a particular competency/module. This may include not only scheduled classes or workplace visits but also the amount of effort required to undertake, evaluate and complete all assessment requirements, including any non-classroom activities.

Course Code




Learning Mode

Teaching Period(s)

Course Contact: Program Manager

Course Contact Phone: +61 3 9925 4468

Course Contact Email:

Course Description

This unit specifies the competency required to determine installation requirements and to fabricate, install and test steel pressure pipe.  It applies to pipe systems with operating pressures not exceeding 1750 kPa and 200 degrees C.
Work associated with this unit is undertaken within the plumbing and services sector in accordance with relevant Australian Standards.

Pre-requisite Courses and Assumed Knowledge and Capabilities


National Competency Codes and Titles

National Element Code & Title:

BCPMS3001A Fabricate and install steel pressure piping


1. Prepare for work
2. Identify installation requirements
3. Fabricate, install and test pipe system
4. Clean up

Learning Outcomes

Overview of Assessment

Assessment may incorporate a variety of methods including written/oral activities and demonstration of practical skills to the relevant industry standards.
Participants are advised that they are likely to be asked to personally demonstrate their assessment activities to their teacher/assessor.   Feedback will be provided throughout the course.